Owner`s manual

Programming Radio Systems
60
• See“Setting the Motorola Status Bit (Motorola
Systems Only)” on Page 76
• See “Setting the End Code Operation (Motorola
Systems Only)” on Page 77
• See “Setting I-Call (Motorola and EDACS Systems
Only)” on Page 77
• See “Setting Emergency Alert (Motorola and
EDACS Systems Only)” on Page 78
• See “Adjusting the P25 Level (Motorola and
Conventional Systems Only)” on Page 79
• See “Setting Control-Channel Only (Motorola
Systems Only)” on Page 78
• See “Reviewing Locked Out Frequencies” on
Page 79
• See “Setting System Attenuation (Trunked
Systems Only)” on Page 81
• See “Deleting Systems” on Page 81
• See “Copying Systems” on Page 81
• See “Setting System Frequencies” on Page 64
• See “Entering/Editing Motorola Channel Groups”
on Page 62
Select the system
Input a system frequency, then press the scroll
control.
To enter additional frequencies, press , use the
scroll control to select , then repeat
the above.
If you select Control Channel Only mode (see
“Setting Control-Channel Only (Motorola Systems
Only)” on Page 78), you only need to enter the
frequency(s) that can be assigned as the control
channel. Most frequency lists usually indicate which of
Setting System Frequencies
Program System
Set Frequencies
New Frequencies
New Frequency
Note: