Manualshelf

User Manual

ManualsBrandsUniden ManualsElectronicsDigital Mobile TrunkTracker V Scanner, 25,000 Dynamically Allocated Channels, Close Call RF Capture Technology, 4-Line Alpha display, Base/Mobile Design, Phase 2, Location-Based Scanning
31323334353637383940
34
Set Delay Time
Sets the delay (in seconds) the amount of time the scanner stays on a channel after the
transmission ends before moving to the next channel. A negative delay forces a resume after that
number of seconds. This setting applies to all channels in the system. You cannot set the delay on
a ‘per channel’ basis. The default setting is 2 seconds.
1. Scroll to ‘Set Delay Time’ and press E/ .
2. Scroll to the desired delay time (-10, -5, -2, 0, 1, 2, 5, 10, or 30 secs.) and press E/ to
save and exit.
Set Record
Enables the REC jack for marked channels, no channels, or all channels in the system. The
default setting is Off.
1. Scroll to ‘Set Record’ and press E/ .
2. Scroll to one of 3 settings and press E/ to save and exit.
All Channel - The scanner sends the audio for all channels in the system to the REC
jack, regardless of the channel’s record option setting.
Marked Channel - The scanner only sends the audio for channels that have the record
option turned on to the REC jack.
Off - The scanner does not send any audio from any channel in the system to the REC
jack, even if the record option is turned on for a channel.
Set Audio AGC
Allows you to turn the AGC feature on or off for the system. See also Adjust Audio AGC.
1. Scroll to ‘Set Audio AGC’ and press E/ .
2. Scroll to ‘Analog’ and press E/ to toggle on or off.
3. Scroll to ‘Digital’ and press E/ to toggle on or off.
4. Press MENU to return.
P25 Waiting Time
This setting sets the amount of time the scanner takes to determine if channels on conventional
systems have digital or analog transmissions. During this time, the scanner evaluates the received
signal and, if it detects P25 data, opens squelch immediately. If P25 is not detected before the
delay expires, the scanner opens squelch at the end of this delay. This is to prevent “false decode”
problems (digital noise at the beginning of transmissions). The default setting is 400 ms. This
setting only affects conventional channels with an Audio Type set to ‘All’.
1. Scroll to ‘P25 Wait Time’ and press E/ .
2. Set the Wait Time from 0 to 1000 ms and press E/ .
Note:AnyanalogtransmissionsonchannelswithAudioTypesettoAlllosetherstpartof
the transmission, up to the wait time you set here.
To Edit the System Name:
1. Press MENU.
2. At ‘Program System’ press E/ .
3. At ‘Select System’ scroll to the system you want to name and press E/ .
4. At ‘Edit Name’ press E/ . See Entering Text.