User Manual

Edit Fleetmap (Motorola

Type I/IIi only)

Set ID Format (no EDACS

SCAT)

P25 NAC Option (P25-1Tr only)

Priority ID Scan (no

EDACS SCAT/P25-1Tr)

Set Record

Set Number Tag allows you to number a system. The default setting is no number tag (blank).

See also Using Number Tags.

1. Scroll to ‘Set Number Tag’ and press E/ .

2. Enter the number tag (0-999) (Press .No to clear the display) and press E/ to save and

exit.

ID Scan/Search (no EDACS SCAT) sets whether the scanner scans the programmed ID groups

(ID Scan) or searches for all IDs (ID Search) in a trunking system. The default setting is ID search.

1. Scroll to ‘ID Scan/Search’ and press E/ .

2. Scroll to ‘ID Scan’ or ‘ID Search’ and press E/ to save and exit.

Note: You can also toggle this while scanning each trunked system by pressing then

SCAN/SEARCH.

Set Delay Time sets the delay (in seconds) the amount of time the scanner stays on a channel

after the transmission has ended before moving to the next channel. A negative delay will force

a resume after that number of seconds. This setting applies to all channels in the system. You

cannot set the delay on a ‘per channel’ basis. The default setting is 2 seconds.

1. Scroll to ‘Set Delay Time’ and press E/ .

2. Scroll to the desired delay time (-10, -5, -2, 0, 1, 2, 5, 10, or 30 secs.) and press E/ to

save and exit.

Edit Fleetmap (Motorola Type I/IIi systems only) allows you to select a preprogrammed

eetmap or program a eetmap for Motorola Type I systems. You must program a system eet

map in order for the scanner to properly track and display talkgroup ID’s.

1. Scroll to ‘Edit Fleetmap’ and press E/ .

2. To select a Preset Fleetmap, scroll to ‘Preset’ and press E/ .

3. Scroll to the number of the preset eetmap and press E/ to save and exit. See Preset

Fleetmaps.

4. To program a Custom Fleetmap, scroll to ‘Custom’ and press E/ .

5. At ‘Block 0’ scroll to the size code (0-14) and press E/ See Size Codes.

6. The scanner will prompt you to the next available block so you can scroll to and enter the

next size code (0-14) then press E/ .

7. The scanner will prompt you to the next available block so you can scroll to and enter the

next size code (0-14) then press E/ .

8. Repeat for each block as needed (0-7) and you will return to the ‘Edit Sys Option’ menu.

Note:Ifyouselectsizecode12,13,or14,theserestrictionsapply:

• 12 can only be assigned to Blocks 0, 2, 4 or 6.

• 13 can only be assigned to Blocks 0 and 4.

• 14 can only be assigned to Block 0.

Since these size codes require multiple blocks, you will be prompted for the next available block.

For example, if you assign Block 0 as 12, the scanner prompts you for block 2, the next block