User Manual

 Any channel groups assigned to this GQK within the current
system only become disabled. (If they were already disabled,
they become enabled.)
Programming Search Keys
1. Open the Search for... menu.
2. Select Set Search Key, then select the search key you want to
program.
3. Select the search range you want to assign to this Search Key.
Choose one of the pre-programmed service search ranges,
one of the 10 custom search ranges, a Tone-Out search, or a
Band Scope search.
Using Search Keys
To start the search assigned to a Search Key, FUNCTION + tap
that Search Key. For example, to start the search assigned to
Search Key 2, FUNCTION + tap 2 .
(You can't use the Search Keys when the scanner is in Scan mode
or GPS mode.)
If the Search Key you select starts a Tone-Out search, the scanner
switches to Tone-Out mode and searches the most-recently-used
Tone-Out channel (out of the 10 available). If you want to search a
different Tone-Out channel, use the SELECT-VOLUME-
SQUELCH knob on handheld models or the SCROLL /
FUNCTIONknob on mobile models to select the Tone-Out channel
you want to use
To use Location-based Scanning with a particular system, you will
need to program your scanner with the geographic coordinates you
want to use for each site or channel group. You can also program
your scanner to alert you when you approach particular locations.