User Manual

ManualsBrandsUniden ManualsElectricalMobile TrunkTracker III
  Programming a location for a site 
  Programming a location for a channel group 
  Programming general locations 
o  To create a new location 
o  For Dangerous Xing and Dangerous Roads only 
o  Edit an existing location 
Programming a location for a site 
Each system site can have separate location information. 
1. Open the Program System menu. 
2. Select the system you want to program for location based 
scanning. 
3. Select Edit Site, then select the first site you want to assign a 
location to. 
4. Select the Set LocationInfo menu and enter the latitude, 
longitude, and range for this site. 
5. Change the Set GPS Enable field to On . 
6. Go back to the Edit Site menu and repeat these steps with any 
other sites you want to program for this system. 
Programming a location for a channel group 
Each channel group in a system can have separate location 
information. 
1. Open the Program System menu. 
2. Select the system you want to program for location based 
scanning. 
3. Select Edit Group, then select the first channel group you want 
to assign a location to. 
4. Select the Set LocationInfo menu and enter the latitude, 
longitude, and range for this site. 
5. Change the Set GPS Enable field to On . 