Owner's Manual

3 on page 4) displays this data. Press and hold the PTT button on the

microphone to see the RF output power levels. Release the PTT button to

see incoming signal strengh.

RECEIVE

Be sure that the power source, antenna, and microphone

are properly connected before proceeding.

1. Turn unit ON. Set VOLUME to a comfortable level.

2. Select CHANNEL.

3. Set noise limitations as desired (ANL/NB).

4. Adjust squelch.

 Turn SQUELCH fully clockwise so only strong signals can get

through.

 Turn SQUELCH fully counterclockwise until you hear a hiss. Every-

thing gets through - noise, weak signals, and strong signals.

 Turn SQUELCH back clockwise until the hiss stops. Only clearer

signals get through.

Set Squelch only when the radio is not receiving a strong signal.

5. Press LO/DX button to set the RF gain sensitivity to Local or

Distance.

6. Press HI/LO to adjust the microphone sensitivity (mic gain)

between LO and HIGH.

TRANSMIT

Perform a voltage Standing Wave Ratio (SWR) measurement prior to using the

transmitter. A SWR ratio in excess of 2:1 may damage the transmitter.

Be sure to read and understand Part 95, FCC Rules and Regulations, before

operating your transmitter.

1. Select a channel.

2. Press HI/LO to adjust the microphone sensitivity (mic gain) be-

tween LO and HIGH.