Owner`s manual

Installing a Line Filter or DSL Filter

Sometimes, broadband Internet services that use the telephone line



static on telephones. A DSL filter or telephone line filter usually solves

this problem. The technician who installed your DSL service might

have left some filters for you; if not, call your DSL provider or look in

any electronics store.

Plug the DSL filter into the telephone wall jack and plug your phone’s

base into the filter. Make a test call to make sure the noise is gone.

Liquid Damage

Moisture and liquid can damage your cordless phone.

 If the exterior housing of the handset or base is exposed to

moisture or liquid, wipe off the liquid, and use as normal.

 If moisture or liquid is inside the plastic housing (i.e. liquid can

be heard in the phone or liquid has entered the handset battery

compartment or vent openings on the base), follow these steps:

Handset Base

1. Remove the battery cover and disconnect

the battery.

1. Disconnect the AC

adapter to cut off

the power.

2. Let dry for at least 3 days with the battery

disconnected and the cover off for

ventilation.

2. Disconnect the

telephone cord.

3. After the handset dries, reconnect the

battery and replace the cover. Recharge the

battery fully (15-20 hours) before using.

3. Let dry for at least

3 days before

reconnecting.

CAUTION! DO NOT use a microwave oven to speed up the

drying process. This will cause permanent damage to the

handset, base and the microwave oven.