User`s guide

12 - English
To... Follow these steps:
skip a message Select 3:Skip.
delete this message Select 4:Delete.
play old messages After the system plays all new messages, select 2:Play.
stop playback Select 5:Stop.
Screening Your Calls
While the system takes a message, you can listen from a handset. Only one
handset can screen calls at a time. If another handset tries to screen calls, it
beeps and returns to standby.
To... Press...
hear the caller leaving a message
MEssaGE/MuTE .
answer the call
TaLk/fLash .
mute the call screen without
answering*
ENd or return the handset to the cradle.
* If you mute the call screen, the system connues taking the message: it just stops
playing through the speaker.
Using the System While You’re Away from Home
You can dial in to your answering system from any touch-tone phone. Before you
can use this feature, you must program a security code.
Programming a Security Code
With the phone in standby, open the menu; select Answering Setup, then select
Security Code. Use the number keypad to enter a two-digit security code (01 to
99). Press
MENu/sELEcT when you’re finished.
# Remember to make a note of your new security code!
Dialing In to Your System
1. Call your phone number from any touch-tone phone, and wait until the
system answers.
x If you have the Ring Time set to Toll Saver, the system answers after 2 rings
if you have new messages and 4 rings if you don’t. You can hang up during
the third ring.
x If the system is turned off, it answers after 10 rings and beeps sound.
2. During the greeting or beeps, press
0 and immediately enter your security
code. If you enter it incorrectly 3 times, the system hangs up and returns to
standby.