User`s guide

English - 10
1. With the phone in standby, press and hold
#
on any handset. The phone
prompts you to select the number of hours ( 1 - 9 or Always On ) that you
want it to stay in silent mode.
2. To confirm, press
#
or just wait about 5 seconds. The phone displays Silent
Mode On
on each handset.
3. After the selected number of hours, the phone automatically exits silent
mode. To exit silent mode manually, press and hold
#
again.
Multihandset Features
# To use the features in this section, you need at least 2 handsets.
♦ Your base supports a total of 12 cordless handsets: the one that came with
the base and up to 11 DCX160 accessory handsets. Your base also supports
a total of 2 DRX100 range extenders, including any that came with your
phone.
♦ You must register accessory handsets to the base before using them.
(Handsets that came packaged with the base are already registered.)
♦ Handsets that aren’t registered display a Not Registered message. For
registration instructions, see p. 14, or see the accessory handset manual.
♦ If a handset was ever registered to a base, you must reset it before it can
register to a new base; see p. 14, or see the accessory handset manual.
Conference Calling
♦ When an outside call comes in, two cordless handsets and the base can
join in a conference call with the outside caller.
♦ To join a call that’s already in progress, just press
Talk/Flash
on the
handset.
♦ To leave the conference call, hang up normally; the other stations remain
connected to the call.
Call Transfer
To... Press...
transfer a call
inTErcoM/clEar
. The phone puts the call on hold and
prompts you to select the handset you want to page.
When the other handset accepts the call, you'll be
disconnected (press
Talk/Flash
to rejoin the call).
cancel a transfer
Talk/Flash
to return to the call.
accept a
transferred call
inTErcoM/clEar
to answer the page and speak to the other
handset. Then, press
Talk/Flash
to speak to the caller.