Owner's Manual

24 - English
Using the System While You're Away from Home
You can also operate your answering system from any touch-tone phone.
Before you can use this feature, you have to program a security code
Programming a Security Code
1. With the phone in standby, open the menu. Select
Answering Setup
, then
select
Security Code
.
2. Use the number keypad to enter a two-digit security code (
01
to
99
). Press
MeNU/Ok
when you’re finished.
#
Remember to make a note of your new security code!
Dialing in to Your System
1. Call your telephone number and wait for the system to answer.
-
If you have the
Ring Time
set to
Toll Saver
, the system answers after 2
rings if you have new messages and 4 rings if you don’t. You can hang up
during the third ring.
-
If your answering system is off, it will answer after about 10 rings and
sound a series of beeps instead of your greeting.
2. During the greeting (or beeps), press
0
and immediately enter your security
code. (If you enter it incorrectly 3 times, the system hangs up and returns to
standby.)
3. The system announces the time, the number of messages in memory, and a
help prompt. It beeps intermittently to let you know it's waiting for a
command.
4. When you hear
beeping, enter a 2-digit
command from the
chart:
#
If you don't press any keys for 15 seconds, the phone will hang up and
return to standby.
IMPORTANT INFORMATION
Solving Problems
If you have any trouble with your phone, check this section first. If you need
help, call our Customer Care Line listed on the front cover.
General problems Possible solutions
No station can make or receive
calls.
x
Check the telephone cord connection.
x
Disconnect the base AC adapter for a few
minutes; then reconnect it.
01 Repeat message
02 Play message
03 Skip message
04 Delete message
05 Stop playback
06 Turn the system on
09 Turn the system off
10 Hear help prompts