Owner's Manual

4 - English
Connect the Power and Telephone Cords
1. Connect the base AC adapter to the power jack and the telephone cord to
the
TEL LINE
jack. Route the cords as shown below:
For desktop use For wall mount use
DESK
WALL
DESK
WALL
DESK
WALL
WALL
DESK
2. Plug the AC adapter into a standard 120 V AC power outlet, and connect
the telephone cord to a standard telephone wall jack.
3. If you are mounting the phone on the wall, place the mounting slots over the
pins on the wall plate, and slide the base down to lock it into place.
Test the Connection
Pick up the corded handset from the base. You should hear a dial tone and the
display on the base should say
Talk
. When you get a dial tone, make a quick
test call.
If... Try...
the display says
Check Tel Line
or you
don't hear a dial tone
checking the connection between the base
and the phone jack.
you keep hearing a dial tone changing to pulse dialing.
Changing from Tone to Pulse Dialing
Your phone uses tone dialing by default. If your phone company uses pulse
dialing, you need to change your phone’s dial mode.
1. Press
MeNU
on the base or
MeNU/Ok
on the handset and select
Advanced Setup
(see p. 10 for using the menus).
2. Select
Dial mode
, then
Pulse
. You'll hear a confirmation tone.
To send DTMF tones during a call (e.g., for an automated response system),
press
to temporarily switch to tone dialing. When you hang up, the phone
automatically returns to pulse dialing.