Digital Spread Spectrum Owner's Manual

Beforeconnectingyour
phoneline,fullychargethe
Nickel-MetalHydridebattery
packfor 15-20hours.
Placethepowercordso
thatit doesnot createatrip
hazardorwhereit could
becomechafedandcreatea
fire or electricalhazard.
Use only the Uniden AC
adaptor supplied with this
phone. Make sure it is
switched ON at all times.
DESK INSTALLATION'
Your DS70 can be fitted with a Desk Stand or mounted on the wall.
. Thread both the telephone line cord and the power cord through the semi-circle
hole in the back of the Desk Stand.
. Insert the two tabs, located on the base of the Desk Stand, into the slots on the
bottom of the Base Unit.
. Push down gently until the tab locks into the top of the Base Unit.
. Now connect the telephone line cord and AC power cord into the Base Unit as
shown on page 8.
,
3, pushthedesk
standdown gently
untilthe tablocks
intothe topof the
baseunit
1.telephone line& power
cordsthreadedthrough
the desk stand,
WALLINSTALLATION
Your DS70 can be wall mounted on a standard telephone wall plate.
. Do not install the desk stand.
. Now connect the telephone line cord and AC power cord into the Base Unit as
shown on page 8.
. Position the Base so the mounting studs on the standard telephone wall plate fit
into the holes on the back of the Base Unit.
. Slidethe Base down on the mounting studs until itlocks into place.
7