Digital Cordless Phone OWNER'S MANUAL

Notes:

If there is any foreign matter on the rubber seal located on

the under side of the battery cover, the handset may not

be water resistant.

The rubber seal should be kept clean and replaced every 2

years to ensure the handset is water resistant even if the

seal does not look worn.

• Do not place an excessively dirty handset in the base.

Shake excess water from handset prior to placing back in the

charging cradle.

Installing the Belt Clip

Line up the tabs with the holes on each

side of the handset. Press the belt clip

down until both tabs click into place.

To remove the belt clip, pull both sides

of the clip to release the tabs from the

holes.

Resetting Handsets

If you want to register the handset to a different base or replace a hand-

set with another one, you must rst clear the registration information

from the base and the handset.

1. Press and hold[]and[#]

for at least 5 seconds, until the

SYSTEM RESET menu appears.

2. Select the DEREGISTER HS submenu. WHICH HANDSET?

appears in the display.

3. Move the cursor to select the handset ID to be de-registered from

the list, and then press the OK soft key. DEREGISTER HS

appears.

4. Move the cursor to select YES, and then press the OK soft key.

When ARE YOU SURE? appears, select YES. You will hear a

conrmation tone.

•

9J K EJ *CP F UGV !

*CP F UGV   

*CP F UGV   

$# %- $#%- 1-