Owner's Manual

THE INTEGRATED ANSWERING DEVICE[ 42 ] www.uniden.com
Setting the Ring Time
The ring time setting allows you to set the number of rings the caller hears before your
answering system plays the outgoing message. You can set the ring time to answer
after two, four, or six rings. Setting (Toll Saver), the answering system picks up
after two rings if you have new messages, and after four rings if there are none. This
way, if you make a long distance call to check your messages, you can hang up after
the second ring to avoid billing charges.
1) Press the clock/menu key three times in standby mode.
You hear “Ring time”, the current ring time ([ ] 2, [ ] 4, [ ] 6, [ ] Toll
saver) is displayed on the base. Then you hear the guidance for setting the ring time.
2) Press the select/volume or key until the desired ring time appears.
3) Press the set key to select the new ring time. You hear a confirmation tone, then
the announcement “Ring time” and the new ring time is announced. After a few
seconds, the system announces “To set record time, press menu again”.
DXAI3288-2 2/4/03 1:18 PM Page 42