Specifications

Charging the Battery Pack
Initial Battery Charging
The rechargeable Nickel-Cadmium
battery pack must be fully charged before
using your phone for the first time. We
recommend that the battery pack charge
for approximately 15-20 hours, without
interruption, before plugging the phone
line into your new phone.
1. Place the
Handset on
the Base Unit.
—or—
Hang the handset on the
cradle when the phone
is mounted on a wall.
✽
Make sure to change
the Handset Retainer
before hanging up
the phone.
2. Make sure the
status LED lights.
If the LED doesn’t
light, check to see
that the AC
Adapter is plugged
in, and that the
Handset is making good contact with
the Base Unit charging contacts.
Continuous Battery Charging
For the best battery performance, return the
Handset to the Base Unit at the end of the
day. This keeps the battery fully charged and
avoids the battery “memory effect.”
speaker
volume
play/stop
memo
ogm
page/find
answer
skip
repeat
new delete
status
Low Battery Indicator
When the Battery Pack in the Handset is very low and needs
to be charged, the
talk/batt low LED flashes.
If the
talk/batt low LED begins to flash, the phone is programmed
to limit its functions to save power. The table below describes
what to do to return your phone to normal operation.
DURING A CALL IN STANDBY MODE
Only the t button operates.
None of the buttons will operate.
The Handset beeps and the talk/batt low LED
flashes once every 3 seconds.
The Handset talk/batt low LED flashes once
every 3 seconds.
Complete your call as quickly as possible. You will not be able to make a call.
ReturntheHandsettotheBase Unit for charging. Return the Handset to the BaseUnitforcharging.
✽
Allow 15 to 20 hours without any interruption for the Handset to fully recharge.
talk
talk/batt
record
tone
?
mem rdl/flash ringer/p
volume
channel
1
abc
ghi
def
mno
pqrs
tuv
wxyz
oper
jkl
2
5
8
0
#
4
7
3
6
9
remote
#
123
4
5
6
8
*
EXA915 15