CT301 Cordless Telephone OPERATING GUIDE For Australia and New Zealand unid~n@ -- --- -_.
Important Safety Instructions When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a dry cloth for cleaning. 4.
9. Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock. 1O.Neverpush objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product. 11.To reduce the risk of electric shock, do not disassemble this product, but take it to a qualified service personnel when some service or repair work is required.
CAUTION: TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS BY THE BATTERY, READ AND FOllOW THESE INSTRUCTIONS. 1. Use only the appropriate type and size battery pack specified in the instruction manual provided for this product. 2. Do not dispose of the battery pack in a fire. The cell may explode. 3. Do not open or mutilate the battery pac~ Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed. 4.
About Your CT301 Congratulations on your purchase of the Uniden CT301 Cordless Telephone.The CT301 has been designed and engineered to exacting standards for reliability,long life, and outstandingperformance. To get the most from your CT301, please take a moment to read this Operating Guide thoroughly. Its many features include . Compander Circuitry to assure Iow noise operation comparable to corded phones . Extended-Use, Rechargeable Battery for up to 6 hours of talk time .
Nickel-Cadmium Battery Warning . This equipment contains a Nickel-Cadmium Battery. . Nickel-CadmiumBatteriesmust be disposed of properly. . The Nickel-Cadmium Battery contained in this equipment may explode if disposed of in a fire. . Do not short circuit the battery. . Do not charge the Nickel-Cadmium Battery used in this equipment in any other charger other than the one designed to charge this battery. Using another charger may damage the battery, or cause the battery to explode.
Handset Controls & Functions 0-9,*,# Buttons - Used for dialing numbers. TALK Button - Places the Handset into Talk mode or back to Standby. BATT LO LED - Lights when the Handset is in the Talk mode. Flashes when the battery pack is Iow . andneedsto be recharged. Handset Antenna - User replaceable flexible antenna provides maximum range. Rechargeable Battery Pack - User replac'eable and rechargeable for long, trouble-free service. R (Redial) Button - Redials the last number dialed.
Handset Antenna BA TT LO LED F (FLASH) Button R (Redial) Button TALK Button 0 - 9, * (TONE), # BUTTON * (TONE) ) BUTTON uniden TELLine DC IN 9V I TIP Switch (Australian Model only) Q Rechargeable Battery Pack (Rear) Battery Charge Contacts D Base Antenna -8-
Installing Your CT301 Selecting the Installation Location You should carefutly select the installation location for freedom from excessive heat or humidity (as in a kitchen or bathroom), and away from sources of electrical noise, (such as motors or fluorescent lighting). Provide sufficient space to safely extend the Base Unit antenna fully, and conveniently locate the telephone near a standard 230/240 VAC outlet and telephone line socket.
~ Reversing the Handset Retainer 1. Remove the Handset Retainer from the Base Unit by sliding it upward. 2. Flip the Retainer over so the tab is facing up. 3. Slide the retainer back into the Base Unit. NOTE: If you put the Retainer back into the Base Unit incorrectly, it will jam, and you'll need to pry it up with a screwdriver. Connecting the AC Power Connect the AC power to the unit by plugging the AC adaptor into the back of the Base Unit, and into a standard 230/240 VAC wall outlet.
3. Place the battery pack into the battery compartment. 4. Replace the cover by sliding it on. Make sure not to get the wires from the battery pack caught in the cover. Charging the Battery Pack The rechargeable Ni-Cd battery pack included with your CT301 needs to be charged for approximately 12-16 hours before first use. Place the Handset in the cradle, and the CHARGE LED should light, indicating the battery pack is being charged. After 12-16 hours, your CT301 will be ready to use.
Using Your CT301 Dialing a Number To dial a number with your CT301, first remove the Handset from the cradle. Next, press the TALK button. The BATT LO LED will then light. Dial the number normally, using the number buttons on the Handset. When "donetalking, you can press the TALK button again to hang up, or simply place the Handset back in the cradle. Using the R (Redial) Button The R button dials the last number (up to 32 digits) that you called.
Note: If you don't place the Handset back on the Base Unit, you need to press the TALK button to hang up the phone. You may find that sometimes pressing the TALK button does not hang up the phone, and the error tone will sound continuously. This may occur during conversations under noisy conditions. If this occurs, place the Handset back on the Base Unit, or press the TALK button again while holding the Handset close to the Base Unit.
Care & Mai ntenance Troubleshooti ng If your CT301 Cordless Telephone is not performing up to your expectations, please try these simple steps. If you are still unable to resolve the problems, contact Uniden Customer Service at: Australia(02)559-3100,New Zealand (09)273-8383, during business hours, Monday through Friday. The battery charge contacts on the Base Unit and Handset should be cleaned once a month with a clean dry cloth to ensure consistent trouble free battery charging.
Problem Charge light won't come on when Handset is placed in the cradle. Check Make sure that the Base Unit AC power cord is plugged both into the wall outlet, and into the Base Unit. Make sure the Ni-Cd battery pack is plugged into the Handset. Make sure the Handset is properly seated in the cradle. Clean the charge contacts on the Handset and Base Unit with a clean dry cloth or pencil eraser. (Do not use liquids or solvents.) Audio sounds weak and/or scratchy.
Important Electrical Considerations CAUTION: Electrical energy can perform many useful functions. The CT301 has been designed and manufactured to assure your personal safety. Improper use can result in potential electrical shock and fire hazards. Please carefully read all safety and operating instructions before installation and use. Keep these instructions handy for future reference. Pay special attention to all the warnings on the unit and in the Operating Guide.
Telephone Line Problems If you are having trouble with your telephone service, you must first disconnect the CT301 to determine if it is the cause of your problem. If you determine that it is the cause, you must leave it disconnected until the trouble has been corrected. Radio Interference Radio interference may occasionally cause buzzing and humming in your cordless Handset, or clicking noises in the Base Unit.
Specifications General FrequencyControl Modulation Operating Temp Base Receive Frequency Transmit Frequency Power Requirements Size Weight Handset Transmit Frequency Crystalcontrolledtransmission FM -10°C to 50°C 39.775 to 40.000 MHz (1 Channel) 30.075 to 30.300 MHz (1 Channel) 230/240 VAC, 50 Hz, AC adaptor 83 x 208 x 48 mm (WDH) Approx. 241 g Weight 39.775 to 40.000 MHz (1 Channel) 30.075 to 30.300 MHz (1 Channel) Rechargeable Ni-Cd Battery Pack 56 x 198 x 49 mm (WDH) Approx.
r CUT -17 - C~~ I I Wall mount template IMPORTANT: ~$I I Before mounting, select a wall area of sufficient strength. If mountingon wallboard or in an area of ques~ionablestrength, locate a stud for maximum support of your telephone. ;;'iIO- I I - ffi L W I I I - I -18- -...
WARRANTY UNIDEN CT301 1 YEAR WARRANTY (Batte~ies and Accessories are covered for 90 Days ONLY) Note: Please keep your sales docket as it provides evidence of warranty. Warranty is only valid in the country where the product has been purchased. WARRANTOR: Uniden Australia Pty.
unid~n Quality goes the Distance UDZZO1366ZA Printed in Hong Kong ""
