Full Product Manual

- 21 -
BASIC OPERATIONS
HOW DO I ...? TRY THIS...
Turn on the R7 Be sure the unit is connected to power and then press
POWER. The unit turns on and runs through an initial
self-check if Self Test is turned on. It displays the
different bands and their settings.
The R7 turns on automatically when you start the
vehicle.
Adjust the volume Press VOL + to increase volume. The unit beeps and
displays a number increase.
Press VOL – to decrease volume. The unit beeps and
displays a number decrease.
Mute alarm audio during
the alert
Press MUTE/DIM during an audio alarm to mute it.
(This is especially useful in situations where the alert
may be prolonged, such as at red lights.) You can also
press the MUTE button on the power cord.
Change the screen’s
brightness
Press and hold MUTE/DIM . The unit displays the
current brightness level. Press MUTE/DIM again.
The R7 announces the brightness level (Bright, Dim,
Dimmer, Dark, or Off) as it changes to that level.
Turn bands on and off Press MENU then + to cycle through the menu options
until the band you want to turn off displays. Press
MENU again to change that band’s status.
Change Highway to City
or set attenuation levels
in Advanced mode and
back
Press MENU. The first menu selection is Highway
(default). Press MENU to cycle through Highway, City,
and Advanced. After you select Highway or City, press
and hold MENU to exit. If you select Advanced, press
+ to select either the K or Ka band to adjust. Press
MENU to adjust sensitivity levels in 10% increments.
Press + again to adjust the other mode.
Set a user mark Press MARK to create a user mark when you are at a
location where there is normally some type of radar.
The R7 announces “User mark logged.” The R7 will
announce when you approach user marks.
R7 stores 2000 points divided between Mute Memory
and User Mark locations.