Full Product Manual

- 29 -
or the MUTE button on the power cord again to save that GPS location to memory.
Mute Memory displays on the screen.
R7 stores 2000 points divided between Mute Memory and User Mark locations.
To delete Mute Memory points, press MUTE/DIM or the MUTE button on the
power cord while Mute Memory displays. The R7 displays a delete confirmation
message; press MUTE/DIM or the MUTE button on the power cord again to
confirm. You can also delete Mute Memory points from Menus/Delete All Mute?
AUTO MUTE/AUTO MUTE VOLUME
When the R7 detects a signal, it sounds an alarm at the current volume level. To
make the alarm quieter, turn Auto Mute on through the menus (see page 18). This
will reduce the volume to the level set (0 - 5) in the Auto Mute Volume menu (see
page 18).
If the current volume level is 0, the R7 will not change the volume to the Auto Mute
Volume level; it will keep the volume level at 0.
Auto Mute ends 10 seconds after the alarm ends unless:
• The same signal is detected within that 10 second period; then, Auto Mute stays
on.
• A different band signal is detected during that 10 second period; then, Auto Mute
turns off and then back on at the current volume level.
Auto Mute does not apply to Laser Alert.
USER SPEED LIMIT
When you set a speed limit thorough the menus, the R7 sends an alarm tone if your
speed exceeds that speed limit setting. If that happens, the unit announces and
displays over speed warnings.
QUIET RIDE
This function mutes X and K band radar alarms when you drive under a speed limit
set in this menu (up to 90 mph/140 km/h). If X or K band signals are detected, the
unit beeps once in volume level one and then goes to volume level zero. Q-Ride
flashes in green on the OLED.
Ka and Laser bands are NOT muted. Mute Memory overrides Quiet Ride.