Specifications

14
Transmit
1. Select the desired talk group as indicated above.
2. Press the PTT key on the side of the unit. Keep the PTT button
depressed while you transmit your message. Notice that the red TX
indicator flashes at least twice while the radio "handshakes" with
the repeater system. Delay speaking until the TX light is steady. If
the Connect Tone is programmed, just wait for it to sound, then
begin talking. If transmission is difficult, try to find a higher
location with fewer obstructions between you and the repeater site.
Release the PTT key when your message is finished.
3. For best voice quality when transmitting, hold the unit vertically
about one inch from your mouth with the top of the microphone
level with your lips.
Telephone operation
1. Select a talk group allowing telephone access, indicated by the
telephone symbol at the left-most end of the display.
2. Press the PTT to access the system, then release to gain dial tone.
3. Transmit the number manually entered or recalled as described
under DTMF Keypad Functions.
4. If someone answers, key the transmitter to talk and release to
listen.
5. When transmission is complete, "hang up" the connection by
pressing the # button on the keypad or the MON/EXIT button.
15
Receive
Select the talk group you want to receive as indicated above. Scan
operation may be activated as described below to automatically
monitor a number of talk groups.
Scan Operation
In the scan mode, the radio monitors each talk group in the selected
system or all systems until it receives a call. You can scan all talk
groups/systems, or you can lock out individual talk a groups/systems
from being scanned.
1. Scan operation may be activated through the MENU operation
or one of the A/B keys may be programmed for that purpose.
• MENU Scan Activation - press and release the MENU key to
display the current scan condition. Press the Up- or Down-
select keys to select the desired condition (SCAN OFF, SCAN
GRP or SCAN SYS). The LCD SC indicator will be displayed
continuously when talk group scan is active and blink when
system scan is selected. Exit menu operation by pressing the
MENU or MON/EXIT keys.
• A/B Key Scan Activation - press and release the A or B key
to activate scan of all talk groups in the selected system. The
LCD SC indicator will be displayed to indicate talk group scan.
Press and hold the key for 2 seconds to activate scan of all
systems, indicated by the flashing SC icon. To deactivate
either talk group or system scan operation, press and release
the A or B key.
2. If scan priority is programmed, receipt of the priority talk group
(first talk group in the selected
system) will be accompanied by
sounding of the Priority Tone.
After the first group, the order of
priority is group 2, the selected
group, then the balance of the
groups in the selected system in
the programmed order.