Specifications

Getting Started

Before you can use your radio, you must install and charge the battery

and install the antenna as follows.

Charging the Battery

Your radio is powered by a specially-designed, nickel-cadmium

battery. You should fully charge the battery before operating the radio.

Only use one of the following chargers.

• Model APX140 Desktop Standard Charger

• Model APX141 Desktop Rapid Charger

Follow the charging instructions that come with the charger. Also be

sure to observe the following warning/safety information for nickel-

cadmium batteries (on the inside front cover of this Operating Guide).

Attaching/Removing the Battery

To attach the battery to the radio,

align the slots in the battery with the

hooks on the radio as shown. Then,

slide the battery toward the top of

the radio until it locks into place.

To remove the battery from the

radio, push the battery release lever

toward the

front of the

radio and

slide the

battery

toward the

bottom of the radio.

the new number for 2 seconds. Additional digits may then be

entered by pressing the 0-9, * and # keys.

4. When all digits are entered, press the Up-select button to store the

number. The displayed number will flash several times and a single

high beep tone will sound to indicate successful storage.

5. To erase a stored number, display it as described above, then press

the Down-select key and hold it for 2 seconds. The display will

show "BLANK " and a dual low tone beep sequence will sound.

6. Exit the memory storage mode by pressing the MENU or MON/

EXIT keys.