Operation Manual

27
Operation
Editing and Erasing a Frequency
Follow the steps to edit the frequency.
1. Press and hold FNC + F/M.
2. Repeatedly press or to move the cursor to
the digit you want to edit.
3. Repeatedly press FNC + or to change the
number.
4. To register the frequency, press FNC + MW.
To move to frequency mode to start searching
from the frequency, RSM/HOLD.
To erase the frequency, press L/O at step 2 and
FNC + WM to confirm. The channel is automatically
locked out.
Scanning the Stored Channels
(Memory Scan)
To begin scanning channels, press RSM/HOLD.
The scanner scans through all non-locked channels
in the Channel Memory (See “Locking Out Channels
in Memory Mode” on Page 30).
You can choose band during scanning from Air, FM
Radio and VHF High.
1. Repeatedly press BAND to select a band you
want to scan.
2. Press or to select turn On or OFF the band.
3. Press PWR or wait for 2 seconds to go back to
Memory Scan Mode.
Note: You can choose the band also in Frequency
Mode with the steps above.
When the scanner finds a transmission, it stops on
it. When the transmission ends, the scanner