Operation Manual

29
Operation
Operation
Turning On The Scanner and
Setting Squelch
Note: Make sure the scanner's antenna is
connected before you turn it on.
1. Turn Squelch fully counterclockwise.
2. Press and hold for about 2 seconds to turn
the scanner on, then turn Volume clockwise until
you hear a hissing sound.
3. If the scanner is scanning, press Hold/ to
stop scanning, then turn Squelch clockwise until
the hissing stops.
Storing Known Frequencies
Into Channels
1. Press Hold/ . Then enter the channel number
where you want to store a frequency, then press
Func + E/Pgm. The channel number appears.
2. Use the number keys and /Clr to enter the
frequency (including the decimal point) you want
to store.
3. Press E/Pgm to store the frequency into the
channel.
Notes:
• If you entered an invalid frequency in Step 2,
Error appears and the scanner beeps three
times. Enter a valid frequency.
• The scanner automatically rounds the entered
number to the nearest valid frequency.
For example, if you enter 28.473 (MHz), your
scanner accepts it as 28.475.
• When you enter a frequency into a channel, the
scanner automatically turns on the delay
function and DLY appears. When delay is turned
UB340ZH Paper OM reduced size.fm Page 29 Monday, September 26, 2005 2:56 PM