Operation Manual

30
Operation
on, the scanner automatically pauses scanning
2 seconds after the end of a transmission before
scanning proceeds to the next channel. To turn
the function off or on, press Func + 5/Dly.
• If you enter a frequency that has already been
entered elsewhere, the scanner sounds an error
tone and displays the channel that was
duplicated. If you entered the frequency by
mistake, press /Clr then enter the correct
frequency. To enter the frequency anyway, press
E/Pgm to accept.
4. To program the next channel in sequence, press
E
/ Pgm then repeat Steps 2 and 3.
Searching For and Temporarily
Storing Active Frequencies
If you do not have a reference to frequencies in your
area, use a search to find a transmission.
Note: When the scanner starts searching, it auto-
matically turns on the delay function. To turn delay
on or off, press Func + 5/Dly.
Scanning the Stored Channels
To begin scanning channels, press Scan/Src.
The scanner scans through all non-locked channels
in the activated banks. (See “Locking Out Channels”
on Page 46 and “Turning Channel-Storage Banks
On and Off” on Page 45). When the scanner finds a
transmission, it stops on it. When the transmission
ends, the scanner resumes scanning.
Notes:
• If you have not stored frequencies into any
channels, the scanner does not scan.
UB340ZH Paper OM reduced size.fm Page 30 Monday, September 26, 2005 2:56 PM