Operation Manual

19
WARNING! If you connect an external speaker to the
scanner's headphone jack, never connect the audio
output line to a power supply and ground. This might
damage the scanner.
ADJUSTING THE BELT CLIP
The factory-attached belt clip makes it easier to carry the
scanner. Use a Phillips screwdriver to adjust (loosen) the
mounting screws or remove the belt clip completely.
POWERING THE SCANNER
You can power the scanner using alkaline (ALK) non-
rechargeable batteries (not supplied) or the included Nickel
Metal-Hydride (Ni-MH) rechargeable batteries. [Uniden provides
a USB cable to charge the Ni-MH batteries on initial installation
and to recharge them through your computer or through a
power adapter that provides USB charge power.]
Inside the battery compartment is a switch to set the unit to
either ALK or Ni-MH.
WARNING! Non-rechargeable batteries can get hot or burst
if you try to recharge them.
CAUTIONS:
• When
 ashes in the display and the scanner beeps
every 15 seconds, recharge or replace the batteries.
• Use only fresh batteries of the required size and
recommended type.
UB374ZV_UBC125XLT_130329.indd 19UB374ZV_UBC125XLT_130329.indd 19 2013/03/29 10:34:502013/03/29 10:34:50