Operation Manual

4. Install two batteries in the compartment as indicated by the

polarity symbols (+ and -) marked inside and replace the cover.

Note: To prevent damage to Ni-MH batteries, never charge them in

an area where the temperature is above 45°C or below 4°C.

Charging the Ni-MH Batteries

The scanner has a built-in circuit that charges the included

Ni-MH batteries when a USB cable connects it to a computer

(NOT to a USB hub) or to an AC or DC adapter that provides USB

charging power. Verify that the battery selection switch is set to

Ni-MH and that only Ni-MH rechargeable batteries are inserted

in the scanner before connecting it to your computer.

CAUTION: Never attempt to charge non-rechargeable

batteries or install non-rechargeable batteries when

the battery selection switch is set to Ni-MH. The USB

cable will only charge the batteries if the scanner is

turned o .

1. Be sure the scanner is turned o . It will recharge only if it

is turned o , even with the USB cable connecting it to a

computer.

2. Connect the included USB cable to the scanner’s USB port.

3. Connect the other end of the USB cable to the computer's

USB port or to an AC or DC adapter that provides USB

charging power.

NOTE: If you connect to a computer's USB port, the PC will prompt

you for the drivers for your scanner. USB drivers and optional

programming software are available for download from

http://www.butel.nl/ubc125xlt . These will also be available on the

CD’s with ARC125 Software.

UB374ZV_UBC125XLT_130329.indd 21UB374ZV_UBC125XLT_130329.indd 21 2013/03/29 10:34:512013/03/29 10:34:51