Operation Manual

49
To start a Quick Search in Scan or Search mode, press Hold
to hold on any channel or frequency. Enter the new frequency
(include a decimal point so you don’t go to a channel) and press
Hold again to set the frequency.
At Quick Search, press Hold to start searching.
To start a Quick Search at the current frequency during Close
Call Search, turn SCROLL CONTROL in Hold mode and press
Hold to start searching.
When the scanner  nds a transmission, it stops on it. When the
transmission ends, the scanner resumes searching according to
the delay setting.
While searching in Quick Search mode, the upper line
displays Quick Search and the lower line displays the
searching frequency and the direction indicator (↑or ↓) with the
modulation.
If you want to change the search direction or if it is a long
transmission and you want to continue searching, turn SCROLL
CONTROL or press Srch/Svc.
Quick Search Receive/Hold Modes
To hold on a frequency press Hold. To step through the
frequencies, turn SCROLL CONTROL in Hold mode. Press Hold
to resume.
While monitoring a transmission, the upper line displays Quick
Search and the lower line displays the current frequency and
the direction indicator (↑or ↓).
UB374ZV_UBC125XLT_130329.indd 49UB374ZV_UBC125XLT_130329.indd 49 2013/03/29 10:34:552013/03/29 10:34:55