Operation Manual

Setting Modulation

You can change the modulations of each band. Selected

modulation a ects both search and Close Call.

For CB band and HAM band, selected modulation also a ects CB

band and HAM band service search.

For Air band, the modulation is AM only.

1. Press Func then 9/Mod to change the modulation while

holding the frequency.

2. The scanner displays the modulation for 1 seconds.

3. Then return previous mode.

Also, you can set Modulation by Search Menu.

Note: If the scanner is turned o , modulation is set to initial setting

except CB band and HAM band.

CLOSE CALL

Using the Close Call Feature

Unlike searching, which requires the scanner to tune to a

frequency to check for a transmission, Close Call RF capture

directly detects the presence of a strong, nearby signal and

tunes to that frequency.

Close Call RF capture works great for  nding frequencies at

venues such as malls and sporting events. You can set the

scanner so Close Call detection works "in the background" while

you are scanning other frequencies, turn o normal scanning

while Close Call is working, or turn o the Close Call feature and

use the scanner normally. You can set the scanner so it alerts

you when the Close Call feature detects a frequency. and you

UB374ZV_UBC125XLT_130329.indd 55UB374ZV_UBC125XLT_130329.indd 55 2013/03/29 10:34:552013/03/29 10:34:55