Operation Manual

20
Using the Scanner Memories
Bank 6 Bank 7 Bank 8 Bank 9 Bank 10
1 1 1 1 1
2 2 2 2 2
3 3 3 3 3
4 4 4 4 4
5 5 5 5 5
6 6 6 6 6
7 7 7 7 7
8 8 8 8 8
9 9 9 9 9
10 10 10 10 10
11 11 11 11 11
12 12 12 12 12
13 13 13 13 13
14 14 14 14 14
15 15 15 15 15
16 16 16 16 16
17 17 17 17 17
18 18 18 18 18
19 19 19 19 19
20 20 20 20 20
21 21 21 21 21
22 22 22 22 22
23 23 23 23 23
24 24 24 24 24
25 25 25 25 25
26 26 26 26 26
27 27 27 27 27
28 28 28 28 28
29 29 29 29 29
30 30 30 30 30
Once you fill out the above chart, follow these steps to enter or change a
frequency in a memory:
1. Press
E/PGM to enter the program mode (the scanner turns on the
PGM icon).
2. If the current channel is not the one you want to program, enter the
memory number then press HOLD.
3. Enter the frequency including the decimal point, then press
E/PGM.
4. To program the next memory, press
▲ or ▼ and repeat step 3.
To program a different memory, repeat from step 2.
5. To exit program mode, press
HOLD or SCAN or change the scanner’s
mode.
UB355ZH(UBC360CLT).indd 20 2008/04/08 15:56:04