Operation Manual

23
Searching for Active Frequencies
Searching for Active Frequencies
Many people enjoy searching for the unknown frequencies that are in
use in their area but are not posted to any site or in any publication.
This scanner radio has two ways to search: Limit searching that searches
between two set frequencies and Aircraft Band Search.
Using Limit Search
Programming an Upper/Lower Limit
Follow these steps to program an Upper and Lower limit for the limit
search:
1. Press
SEARCH then HOLD. The scanner holds on the current search
frequency.
2. Enter one of the range limits, then press
E/PGM.
Press
▲ or ▼ then enter the other range limit , and press E/PGM.
Note:
• By press and hold
E/PGM key, it goes to enter the range limit program
mode.
Searching the Selected Range
After entering the limits (or use the default limits), press SEARCH.
The scanner starts searching from the lower range up to the higher range.
To change the direction of the search, press ▲ or ▼.
Using Aircraft Band Search
Aircraft Search Operation
When MODE switch is moved to Aircraft, scanner goes to aircraft search
mode. In this mode, Aircraft Band Search can be operated.
Searching starts initially when MODE switch is moved to aircraft.
Searching stops at a frequency when transmission is found. Searching
resumes automatically after the transmission ends.
Press SEARCH or ▲, ▼ to start aircraft search when search stops at a
frequency.
Search direction can be changed by ▲, ▼.
UB355ZH(UBC360CLT).indd 23 2008/04/08 15:56:05