Operation Manual

37
Scan the Stored Channels
Press Scan. The scanner scans through all non-locked out
channels in enabled banks. (See page 41 for more information
on locking out channels.) When the scanner  nds a
transmission, it stops on it. When the transmission ends, the
scanner resumes scanning.
Notes:
• If you have not stored frequencies into any channels, the
scanner does not scan.
• If the scanner picks up unwanted partial or very weak
transmissions, press Func and press the scroll control knob.
SqL displays. Turn the knob clockwise to decrease the
scanner’s sensitivity to these signals. To listen to a weak or
distant station, turn the knob counterclockwise.
• Adjust squelch until the audio mutes.
Manually Select a Channel
You can continuously monitor a single channel without
scanning. This is useful if you hear an emergency broadcast
on a channel and do not want to miss any details - even
though there might be periods of silence - or if you want to
monitor a speci c channel.
To manually select a channel when in Scan mode, press
Hold, enter the channel number, and press Hold again.The
scanner moves to the frequency stored in that channel.
During scanning, if the radio stops at a channel you want to
listen to, press Hold once. (Rotate the scroll control knob to
step through stored channels.) Press Hold again or Scan to
resume automatic scanning.
UBC75XLT_UB372BV_20130401.indd 37UBC75XLT_UB372BV_20130401.indd 37 2013/04/02 11:08:362013/04/02 11:08:36