unid~n UH-O54A/ UH-O54L Ultra Light Weight Two Way Radio MEML6~ DU".CAN ..'" f2J 8 UH.O54 power oo 0 1nl () 0 volume chan.... ~ aqU«ch Curmlen .... ... . .. .. ... . . ... . .. .. .. ... ... ..... .... ... . .... . . .... ... .. .... ...... .. ...... .. .............. \l -=::> . ... . ... ... ... ... ...... ' .. ..... ... .. ........ ... ...... ..... ... .. ... . ......... . ... ... .... ... .... . ........ .. P1111'1~11..: ,oil a4. UTZZO1870ZA .... .... ... .. . .. ........... ..
Warning! 1& The UHO54Ais waterproofonlywhen both the antenna and the battery are properly attached. 1& The UHO54Lis a standard NON water proof wearable radio only. 1& Do notoperatethetransmitterof anyradio equipment unless all the Radio Frequency (RF) connectors are secure and any open connectors are properly terminated. 1& Do not operate the transmitter of any radio equipment near electrical blasting caps or in an explosive atmosphere.
Controls and Indicators 1 C> C> C> 5 6 3 7 8 4 9 10 11 2 12 13 14 15 16 ~ 17 Antenna 14 Channel Down button ... 15 Microphone 6 7 Belt Clip PTT (Push to Talk) Key HlilO/LOCK Key LCD Display Scan button Power button B C Transmit Indicator RF Power Level Indicator 8 Duplex button D 9 Priority button E Channel Number Display Battery Level Indicator 2 3 4 5 10 Memory button 11 Speaker 12 Volume button 13 Channel Up button ...
CONTENTS Introduction 2 Features 2 Technical Support and Service. . . 2 Included with Your UH-054 . . . . . . . 4 GettingStarted 5 Mounting the Drop-in Charger. . . . 5 Attaching the Antenna. . . . . . . . 5 Attaching the Battery Pack. . . . . . 6 Charging the Battery Pack. Operation , . . . . . 6 8 Settingthe Squelch. . . . . . . . . 8 Selecting a Channel. . . . . . . . 10 Transmitting 10 Using Repeater Channels. . . . . 11 To Operate UH-054 in Duplex Mode 12 DuaIWatch 13 Scan DropOutdelay.
Introduction The UH-054 is a portable two-way UHF transceiver. It is compact, lightweight, and rugged and fits easily in your hand. This hand held UHF CB Radio will give you the consistent, outstanding performance in virtually all conditions and situations. The UH-054 radio is available in two versions: 1. A Wearable and Waterproof UH-054A * AquaMax Radio. Or 2.
If you require service that is within the terms of your warranty, you should present a copy of your receipt to your dealer to authenticate your claim. If you find it inconvenient to obtain service assistance from a dealer, please pack your radio in a suitable container that will provide adequate protection.
Included with Your UH-O54 UH-O54 Charger AC Adapter ~ Antenna Battery Wrist Strap Operating Guide Product Registration Card Mounting Screws If any of these items are missing from the box, contact your Uniden Dealer.
Getting Started Mounting the Drop-in Charger 1. Mount the drop-in charger to either a counter or wall. ~ 2. Plug one end of the AC adapter into the wall outlet, and the other end into the Dropin Charger. ~ Attaching the Antenna Attach the antenna to the UH-O54. Be sure the antenna is firmly seated.
Attaching the Battery Pack 1. Slide the battery pack onto the bottom of the radio. . u- 1 --0 156 =~~ . ~ t ~ 2. Use a coin to turn the screw that connects the battery pack to the UH-054. Be sure the battery pack fits tightly against the UH054's body. ~ Charging the Battery Pack Your UHF CB radio is powered by a speciallydesigned nickel-cadmium battery pack. 1& Before operating the UH-054, charge the battery pack for 15 hours in the drop-in charger.
1. Place the UH-O54 in the drop-in charger. 2. The red LED lights and stays on. 0 .... ~ ~ The battery pack will not be overcharged by the charger even if the battery pack is not removed from the charger. Do not transmit when the UH-O54is in the drop-in charger! ~ You can monitor incoming calls while the UH-O54 is in the drop-in charger. ~ You can charge the battery pack alone or connected to the UH-O54.
Qperation 1& When you press any key (except PTT), a short tone sounds. 1& See the front of the operating guide for button and key positions. Setting the Squelch 1. To turn the unit on, press and hold the powerbutton for 1 second. ... n 1= MEM P 1= IJ chan buttons to adjust the volume to a comfortable level. 2. Use the volumeand 3. Press the volume button. Press'" on the chan button to adjust the volume up. buttonto adjustthe volume down. Press ,.
Press and hold" on the chan button to adjust the "squelch gate" so high that no signals get through. ... StrongSignals- Medium Signals -- .. .. Weak Signals~ . Ho~se~==::===::==:1 5. Press and hold" on the chan button to adjust the "squelch gate" so everything gets through - noise, weak signals, and strong signals. c' SL ) Strong Signals Medium Weak Signals Signals -~o~se~ = = = = =:: = = =:: = = = = =: ....... 6. To set the "squelch gate" to the desired level, press ..
Selecting a Channel 1. When you turn on the UH-054, the last channel will appear on the LCD display. (e.g. CH01) MEM ... n 1= PU 1= 2. To select a higher channel, press"" on the channel button. 3. To select a lower channel, press'" on the channel button. MEMn PU To quickly change channels, press and hold .... or'" . This will change the channel rapidly. Transmitting The UH-054 uses the 40 UHF CB Channels.
3. When the channel is clear, press the PTT switch to transmit. TX appears on the LCD when you transmit. Hold the radio with the microphone approximately two inches in front of your mouth with the antenna at approximately a 45-degree angle away from your head. Speak in a clear, normal conversational voice. 4. When you are finished speaking, release the PTT switch and listen for an answer. Using a Repeater £hannel UHF CB Repeaters are used to retransmit or relay your signal.
The signal coming from your radio is received by the Repeater station and then retransmitted at the same time on another channel. This operation is called "duplexing". Your UH-054 is designed with the capability to access and use repeater stations. Channels 01 through 08 have the option to operate in Duplex Mode. When any of these channels are set to operate in duplex mode during transmission, the UH-054 automatically sends the signal at a frequency 30 channels above the original.
Dual Watch Dual Watch mode monitors a priority channel and the currently selected channel for a signal. The UH-O54 checks the priority channel for activity every 1.5 seconds. Selecting a Priority Channel The UH-O54 is preprogrammed with CHO1 as the priority channel. However, you can change the priority channel to be any other channel. Note: When you select a new priority channel, the old priority channel automatically becomes a regular channel. 1. The radio should be in Stand-by mode. nu: Ut: 2.
While in Dual Watch Mode, you can use the.. or T to change to a new selected channel while monitoring the priority channel. To cancel dual watch, momentarily press priority button or the PTT. Scan Your UH-O54 has a scanning feature that .allows you to search for active channels automatically. Memory Scanning Memory Scanning scans only the channels stored in the scan memory. 1. To begin scanning, momentarily press the scan button. 2. The SCAN icon flashes as the UH054 looks for a transmission.
. Start memory scanning (as described on the previous section) then momentarily press the priority button. 88 = SCAN - MEM PRI - or . While dual watching, press the scan button. Deleting and Storing Channels in the Scan Memory You may have certain channels that you do not want to hear every time you scan. These are channels that are busy in a major portion of time, and the scanning stops at that channel(s) often enough to interrupt the scan cycle.
2. Then press and hold the mem button. You will hear a single-confirmation tone and MEM icon MEM appears on the display. Drop Out delay While scanning, the UH-O54 stops at a busy channel and receives a transmission. When the received signal is over, the unit will wait for three seconds for the return of the signal, otherwise the radio resumes scanning. Lighted Display The LCD back light automatically switch-on every time a key is pressed. Key Lock To prevent accidental entries, you can lock the keypad.
Battery Level Detection 1. At Power On, the level indicator is always the current battery level when not in Squelch or Volume Adjust Mode. 2. The battery level indicator indicates the current battery voltage level. (Min) ( 03i) ( 03..) ~; C~D3 J (Max) . mID - - - - 1 2 Level -0 -~ 3 4 5 B mmmID - OFF --+B B B Blinks--<".:> mID - -- -- -- -+-- ON - 3. If level 1 is detected when [PTT] SW is pressed, transmit mode will fail, PTT Error Tone will sound and TX icon will blink.
UHFCB Channel Information This radio has been designed to provide a high level of performance in the Citizens Band Radio Service, which is comprised of the following frequency assignments; SIMPLEX Operating Channel 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 18 Mode Channel Frequency in MHz 476.425 476.450 476.475 476.500 476.525 476.550 476.575 476.600 476.625 476.650 476.675 476.700 476.725 476.750 476.775 476.800 476.825 476.850 476.
DUPLEX Operating Mode Channel Assignment CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 Receive Frequency(MHz) 476.425 476.450 476.475 476.500 476.525 476.550 476.575 476.600 Transmit Frequency(MHz) 477.175(CH31) 477.200(CH32) 477.225(CH33) 477.250(CH34) 477.275(CH35) 477.300(CH36) 477.325(CH37) 477.
Parts and Accessories Antenna Standard Battery Pack BP940 Operating Guide Wrist Strap AC Adapter Drop-in Charger HH9485 Cigarette Adapter HH9804 High Capacity Battery Pack BP054 20
S~ecifications General Channels Transmit Receive Freq. Control Freq.Tol. Transmit Receive Oper. Temp. Antenna Microphone Display Speaker Power Source Size Weight 40 40 PLL :t6 ppm :t6 ppm O°C +55°C Flexible Whip Built-in Electret type Liquid Crystal Display 8Q 1 Watt Rechargeable Nickel-cadmium Battery Pack 4.
Hum & Noise Ratio Audio Output Power Current Drain Squelched Max.Audio 45 dB 0.6 W @10% THD Charger Input Voltage Std. Power Supply 9 V - 12 V DC AAD-050S N/13809 Input=230-240V AC,50Hz 45mA 280 mA Output= 9 V DC,210 mA Specifications shown are typical and subject to change without notice.
Warranty Uniden UH-054 UHF CB Radio One Year Warranty Note: Please keep your sales docket as it provides evidence of warranty. WARRANTOR: Uniden Australia Pty. Limited ACN 001 865 498 Uniden New Zealand Limited ELEMENTS OF WARRANTY: UNIDEN warrants to the original retail owner for the duration of this warranty. Its UH054 UHFCB Transceiver Radio (hereinafter referred to as the Product) to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below.
I I I I I I I I I i I ! I I I I ! I I ! I I I I, i uniden~ @1997 Uniden Australia Pty Ud. All Rights Reserved.
