Owner`s manual

Operation - Special Features
27
UNIDEN UH8080NB UHF CB Transceiver
100 User Programmable RX Channels
The UH8080NB has 100 receive only channels (CH81 to CH180) which can be
programmed with frequencies ranging from 400-520MHz (in 12.5kHz steps). The extra
RXchannelsonlyappear,aspartoftheCBchannelbank,whenafrequencyhasbeen
programmed to a channel. There are three ways to programme RX channels;
1. If you know the frequency you may manually programme it to a channel.
2.StoreaPoliceorFire(&Ambulance)frequencytoachannel.
3.UsetheCloseCallRFCapturefeaturetondanearbystrongsignal&storethis
frequency to a channel.
Furthermore,theRXchannelscanbeAlphaTagged(givenaname)ifdesired.
Manually Programme a RX Channel
In CB channel mode (UHF CB channel);
1.Press&hold[MENU].ThelowestavailableemptyRXchannelwillash.
2. Press
/ if you wish to select another RX channel.
3. Press [SQL]tobeginthefrequencyedit.TheMHzdigitrangeashes.
Use
or toshiftbetweenMHzrange(between400-520MHz)&kHzrange(in
12.5kHz steps).
Press and hold
/ toselectthedesiredfrequencywithinMHz&kHzranges.
4. When desired frequency is entered press [SQL] to move to Alpha Tag selection. A
 cursorashesinthe1stalphaposition.
If you do not wish to name the channel then skip this step.
Press and hold
/ to select the desired alpha character.
Use
or to shift between cursor positions.
5.Whennishedpress[SQL].Alongconrmationtonesoundstoindicatethenew
channel is programmed.
Thechannelashestoenableselectionforprogrammingofnextchannelifdesired.
6. Press and hold [ENTER],orwaitfor10sec,toexitprogrammingmode.