Owner`s manual

33
UNIDEN UH8080NB UHF CB Transceiver
Operation - Special Features
Programming the Selcall ID for your UH8080NB
The radio Selcall ID is the ID other users will identify as being your radio. It is set in the
Selcall settings menu as follows:
1. Power Off the UH8080NB.
2. Press and hold [POWER] and [MENU]. The UH8080NB should turn on in the
SELCALL Menu selection state (no tone will sound). Cd dispays to indicate the Call ID
setting (factory default ID is 00000).
3. Press [SQL]tobeginthefrequencyedit.The5thdigitoftheIDashes.
4. Use
or to shift between digits. A 6th digit (for 6 tone Selcall) is available and
indicated by a ‘_’.
5. Press
/ to select the desired ID.
6. Press and hold [ENTER] to exit the setting mode.
7. Press and hold [ENTER] again to exit programming mode.
Alongconrmationtonesounds.
Storing Selcall IDs of other users to the ID Memory
1. Press and hold [SELCALL]. The Selcall ID memory will open.
2. Press
/ to select the desired memory slot to edit.
NOTE
•Upto10IDmemoriescanbestored.
•IfyouexpecttomakecallstoradiosnotstoredintheIDmemorythen
leave memory ID 1 blank for manual ID entry at the time of the call.
3. Press [SQL]tobegintheIDedit.The5thdigitoftheIDashes.
4. Use
or to shift between digits. A 6th digit (for 6 tone Selcall) is available and
indicated by a ‘_’.
5. Press
/ to select the desired ID.
6. When desired ID is entered press [SQL] to move to Alpha Tag selection.
Acursorashesinthe1stalphaposition.Thedefaultaplhatagisblank-displaysas
No Name. If you do not wish to name the ID then skip to step 9.
7. Press and hold
/ to select the desired alpha character.
8. Use
or to shift between cursor positions.
9.Whennishedpress[SQL].AconrmationtonesoundstoindicatetheIDis
 programmed.Thememorynumberashestoenableselectionforprogrammingof
next memory if desired.
10. Press and hold [ENTER],orwaitfor10sec,toexitprogrammingmode.