Owner`s manual

36
UNIDEN UH8080NB UHF CB Transceiver
Operation - Special Features
Scanning Tone Squelched Channels
IfyouareusingtwoormoreChannelsintheTSQmode,youcanmonitorallofthese
Channels for selective calls by using the TSQ scanning feature.
To use this feature start the TSQ Scan by pressing and holding [TSQ] for 2 seconds
during Open Scan or Group Scan.
UnlikeNormalScanning,TSQscansandchecksdetectedsignalsforSelcallinformation.
Ifthisinformationisnotfound,TSQScanningresumes.
WhenacallisreceivedduringTSQScanning,UH8080NBfollowsthesameresponseas
when receiving a call on a Tone Squelch Channel. It differs only in the following ways:
1.Ifthecallisnotansweredwithin20seconds,TSQScanningresumes.
The CAL icon remains on the LCD display.
To look for the Channel where the CALL is received.
a) Cancel TSQ Scanning by pressing [SCAN].
b) Using
/ ,browsethroughtheTSQChannels.TheCALindicator
marks the Channel where the Call is received.
2.Whenanswered,TSQScanningisautomaticallydeactivated.TheChannelisremoved
from the QUIET Operating Mode.
To deactivate TSQ Scanning:
a) Press and hold [TSQ] for 2 seconds.
The unit returns to Normal Scanning Mode.
b) Press [SCAN].
The whole scanning operation is cleared.
 c)WhenaSelcallisreceived,press PTT.
NOTE
The chance of receiving and decoding Selcalls effectively during TSQ
Scanning can be increased in many different ways. You can either
decrease the number of channels to be scanned thus increasing the
scanning speed – or – change some of the Selcall parameters (refer to
‘Selcall Programming’).