Use and Care Manual

English

Event SAME Code Type

Wild Fire Watch WFA Watch

Wild Fire Warning WFW Warning

Unrecognized Watch **A Watch

Unrecognized Emergency **E Statement

Unrecognized Statement **S Statement

Unrecognized Warning **W Warning

No Response Event Code

TXB Transmitter Backup On

TXF Transmitter Carrier On

TXO Transmitter Carrier On

TXP Transmitter Primary On



This radio supports NMEA0183 version 3.01.

NMEA Input

If you have difficulty getting your radio to receive data from your GPS receiver, check the

device’s configuration. It should be set to the following parameters:

Baud rate 4800 bps

Data bits 8

Parity None

Stop bits 1

Data amplitude Over 3.0 V

Drive capability Over 10 mA

The radio supports RMC, GLL, GNS, GGA and ZDA sentences. When these sentences are

received, the radio displays latitude/longitude, date, time, course, and speed. If any sentence

except an RMC or GLL sentence is received, the radio uses the information based on the

following priority order.

Status:RMC > GLL > GNS > GGA

Latitude/Longitude:RMC > GLL > GNS > GGA

UTC Time: RMC > GLL > GNS > GGA > ZDA

Date: RMC > ZDA

Speed / Course:RMC

NOTE 1: If the radio receives only a GLL sentence, the radio does not display the current

speed, course, and date.

Note 2: If the radio receives both RMC and GLL sentences, the radio uses only the RMC

sentence.

Note 3: Status data is used to check whether the GPS data is valid or invalid.



