How to Guide

In scan mode, you can get the following information from the display (some indicators will

not always be displayed).

Using the radio in scan mode

x You cannot transmit while in scan mode.

x You must have two or more channels in memory to start a scan.

x To save a channel into memory, select the channel, then press and hold



for

two seconds. Memory will show on the display.

x To remove a channel from memory, set the radio to that channel, then press and hold



for two seconds. Memory will no longer show on the display.

x To activate scan mode, press and hold



. Press and hold



again to

return to the previous mode.

x When the radio automatically stops on a channel, press

CHANNEL UP

to leave that

channel and resume scanning.

x To end the scan, press the microphone’s

PUSH TO TALK



, or



buttons. The radio remains on the last scanned channel.

Scan mode with Weather Alert Watch

If you activate Weather Alert Watch while operating in scan mode, the radio checks the

most recently-used weather channel every seven seconds, then continues scanning the

next channel in memory.

To turn Weather Alert Watch on or off, press and hold



while the radio is idle.

Select Setup and then WX-Alert Mode. Use

CHANNEL UP

and

CHANNEL DOWN

to choose WX

Alert Mode setting ON or OFF.