How to Guide

INSTALLING THE HARDWARE

MOUNTING THE RADIO

Your radio can sit at any angle in the mounting bracket so it can easily accommodate

the best location. First, determine the best place to mount the radio. For optimum

performance, find a location that can:

x Properly support the weight of the radio, approximately 2.2 pounds or 1.0 kilograms.

You may need to use some type of anchor with the mounting screws to hold the radio,

depending on the surface.

x Keep the battery leads as short as possible.

x Keep the antenna lead-in wire as short as possible.

x Allow free air flow around the heat sink on the rear of the radio.

x Avoid interference with the ship’s compass.

1. Install the radio into the mounting bracket.

2. Position the radio into the desired location. Mark the edges of the bracket on the

mounting surface.

Step 2:

Tighten the mounting

knobs to secure the

radio in place.

Actual product image may vary.

Step 1:

Slide the radio into

the mounting bracket.

3. Use the mounting bracket template (included) to mark the drill holes on the mounting

surface.

4. Drill the holes for the mounting bracket; be sure to follow any special requirements of

the mounting surface.

5. Remove the bracket from the radio, and use the mounting hardware to secure the

bracket to the mounting surface.

Install the radio back into the mounting bracket.