Specifications

Low Battery Indicator
When the Battery Pack
in the Handset is very
low and needs to be
charged, the
TALK/BATT LOW LED
flashes.
If the
TALK/BATT LOW LED begins flashing, the
phone is programmed to eliminate its functions to
save power. The table below describes what to do
to return your phone to normal operation.
During a Call In Standby Mode
Only the T button
operates.
None of the buttons will
operate.
The Handset beeps and
the
TALK/BATT LOW LED
flashes once every 3
seconds.
The Handset
TALK/BATT
LOW
LED flashes once
every 3 seconds.
Complete your call as
quickly as possible.
You will not be able to
make a call.
Return the Handset to
the Base Unit for
charging.
Return the Handset to
the Base Unit for
charging.
Note: Allow 15 to 20 hours without any interruption
for the Handset to fully recharge.
Setting the Pulse/Tone Switch
Be sure the pulse-tone
switch is in the tone
position.
Note: Most phone systems are Tone dialing. Check
with your local phone company if you are not
sure whether your system is Tone or Pulse
dialing.
Setting the Handset Listening
Volume
You can choose two different volume settings
when using the Handset during a call. When the
Handset is first used, the volume will be at its
normal setting. However, you can change to a
higher volume by pressing
V
during a call. To
return to the normal volume, press
V
again.
Setting Handset Ringer Volume
You can choose between two different ringer
styles, each with a high and low volume. To select
the style and volume you like best, press the
G
key until you hear the desired setting.
Note: Just remember to select your Hanset ringer
style and volume when you’re not using the phone
for a call.
Setting the Base Ringer
Volume (XCA555 Only)
To adjust the Base Unit
ringer volume, set the
ring vol-off lo hi switch to
the desired setting.
pulse-tone
ring vol
OFF-LO-HI
16 XCA550/55
550CH2.CHP
Fri Aug 01 15:25:09 1997
Color profile: Disabled
Composite Default screen