User's Guide

USER GUIDE: UBS-200L LF DESKTOP READER
April 4, 2019
Unified Information Devices | Chapter 3 – Operating and Configuring the UBS-200L
22
Appendix 1 – Default Settings and Response/Error Codes summarizes which
Module parameters are safe to change and which should be left
unchanged.
Advanced Configuration Commands
Commands and parameters listed in this section are only adjustable after a successful log-in using the
“UID USRLOG” command.
Advanced Log-in “UID USRLOG”
Issue the “UID USRLOG” command followed by the User Log-in Password to enter the UBS-200L
Advanced Configuration mode. Contact UI Devices for additional information regarding the User Log-in
Password.
Change Advanced User Password “UID CHGPW”
Contact UI Devices for assistance with changing the Advanced User Log-in Password.
Reset Advanced User Password “UID RSTPW”
Contact UI Devices for assistance with resetting the Advanced User Log-in Password.
Sound On/Off “UID SND”
Issue “UID SND 0” to turn off all sounds emitted by the unit, including transponder read confirmation
tone, antenna change chirp, and start-up fanfare.
Issue “UID SND 1” to turn sounds back on.