Instruction manual
GAS/NO-GASSELECTION
The welder can be congured to weld, with or without a gas supply according to the
type of welding wire being used.
· Solid core (With Gas),
· Flux Core (No Gas)
WELDINGWITHGAS
1. If using solid wire, connect the terminal as shown.
· The earth cable (Thicker Lead) should be connected to the negative (Black) terminal.
· The cable from torch (Thinner Lead) should be connected to the positive (Red)
terminal.
CONNECTINGTHEGASSUPPLY
2. Refer to instruction manual supplied with regulator
Connect a bottled gas supply to the small tube at the back of the welder. Adjust the
argon regulator to deliver 12 -18 Litres per min.
WELDINGWITHOUTGAS
1. If using ux cored wire, connect the terminal as shown.
· The earth cable (Thicker Lead) should be connected to the positive (Red) terminal.
· The cable from torch (Thinner Lead) should be connected to the Negative (Black)
terminal
17 5
19 5
220V
230V
220V
230V
UNI-PLAS UNI-PLAS