Owner`s manual

Outdoor LP Gas Barbecue Grill Model No. NPG2302SS
Assembly Instructions (continued)
9
Lock Lid
Unlock Lid
10
Fold Up Legs
Note: Always lock lid before folding legs.
Unfold Legs
Note: Always open legs completely and are secured in place before lighting.
This grill is designed to operate with a one pound
7.75” or 10.6” high disposable / 16.4 oz. or 14.1 oz.
propane gas tank (DOT 39 Cylinder) (Figure 1)
DO NOT ATTEMPT TO REFILL ANY ONE POUND (16.4
oz. or 14.1 oz.) PROPANE GAS TANKS!
Connect LP Gas Tank
Only cylinders marked “propane” may be used.
Note: Some 1-lb cylinders may form frost when near
empty.
1. Make sure the regulator/control knob is in the
“OFF
” position (Figure 2).
2. Lubricate the threads of the regulator/control
knob with petroleum jelly. Line up threads on LP
gas tank with regulator/control knob.
3. Insert and rotate LP gas tank clockwise until
they fit snugly together. HAND TIGHTEN ONLY. Be
careful not to cross threads when screwing in
canister
(Figure 3).
4. Test for leaks. See “Checking for Leaks” section.
Disconnect LP Gas Tank
1. Turn the regulator/control knob to the “OFF ”
position (Figure 2).
2. Rotate LP gas tank counterclockwise until it is
loose (Figure 4).
3. Store the LP gas tank in a proper location, per LP
gas tank instructions.
Checking for Leaks
Burner Connections
1. Make sure the regulator/control knob is securely
fastened to the burner.
Note: The brass nut should be 1/4 to 1/2 turn past
tight. The regulator will rotate 360º even when the
brass nut is tightened.
If your unit was assembled for you, visually check
the connection between the burner and regulator/
control knob (Figure 5).
W WARNING: Failure to inspect this
connection or follow these instructions
could cause a fire or an explosion
which can cause death, serious bodily
injury or damage to property.
2. If the burner and regulator/control knob do not
fit properly or if you have any questions, please
contact 1.800.762.1142 for assistance.
Tank/Gas Line Connection
1. Make 2-3 oz. of leak solution by mixing one part
liquid dishwashing soap with three parts water.
2. Make sure regulator/control knob is in the
“OFF
” position (Figure 2).
3. Spoon several drops of solution, or use squirt
bottle, at all “X” locations (Figure 5).
a. If any bubbles appear remove the LP gas
tank and reconnect, making sure the
connection is secure.
b. If you continue to see bubbles after several
attempts, remove the LP gas tank per
“Disconnect LP Gas Tank” instructions, and
contact 1.800.762.1142 for assistance.
c. If no bubbles appear after one minute, wipe
away solution and proceed.
First Use
1. Make sure all labels, packaging and protective
films have been removed from the grill.
2. Remove manufacturing oils before cooking on this
grill for the first time by operating the grill for at
least 15 minutes on
(HIGH) with the lid closed.
This will “heat clean” the internal parts and
dissipate odors.
Figure 1
1 lb
453 g
7.75 in. / 19,7 cm
3.875 in. / 9,8 cm
2.9 in. / 7,4 cm
1 lb
453 g
10.6 in. / 26,9 cm
Figure 2
O
F
F
A
R
R
Ê
T
Figure 3
Figure 4
Figure 5
X
X
Figure 6
Match
Figure 7
1/2"
12,7 mm
6,4 mm
0 mm
1/4"
0"
Flame
Operating Instructions