User's Manual

V1.4
Professional Computer Technology Limited
Confidential
7
Module Specification
433MHz Transceiver IC Amiccom A7108
Data Rate 150k bps
Modulation FSK
Typical range 10~200M
Output TX Power Max 1.67dBm
Frequency Hooping NO
Operation Power
433MHz:30mA@10dBm, 70mA @ 17dBm
Standby Power < 10uA
NT1R N = 64
Encryption Microchip KEELOQ /CRC
GPIO 1
Switch 2
LED 1
Communication Port UART
FCC Warming:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful
interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications are not expressly
approved by the manufacturer could void the user's authority to operate the equipment
The following sentence has to be displayed on the outside of device in which the transmitter module is
installed "Contains FCC ID: TFJFSK7108"