Operation Manual

administration.fm
A31003-C1000-M102-9-76A9, 08/2018
OpenScape Desk Phone CP100/200/CP205/CP400/CP600/600E HFA, Administration Manual
59
Administration
IP Network Parameters
3.3.2 Use DHCP
If this parameter is set to "Yes" (default), the phone will search for a DHCP server on startup
and try to obtain IP data and further configuration parameters from that central server.
If no DHCP server is available in the IP network, please deactivate this option. In this case, the
IP address, subnet mask and default gateway/route must be defined manually.
The following parameters can be obtained by DHCP:
Basic Configuration
• IP Address
• Subnet Mask
Optional Configuration
• Default Route (Routers option 3)
• IP Routing/Route 1 & 2 (Static Routes option 33), Classless static route option 121, Pro-
vate/Classless Static Rout (Microsoft) option 249)
• Primary/Secondary DNS (DNS Server option 6)
• DNS Domain Name (DNS Domain option 15)
• SNTP IP Address (NTP Server option 42)
• Timezone offset (Time Server Offset option 2)
• VLAN ID, DLS address (Vendor specific Information option 43)
Administration via WBM
Network > General IP configuration
>
The change will only have effect if you restart the phone.
The phone is able to maintain its IP connection even in case of DHCP server failure.
For further information, please refer to DHCP Resilience.
LLDP-MED enabled
DNS domain
Primary DNS
Secondary DNS
General IP configuration
osbiz
DHCP enabled
Submit
Reset
VLAN discovery
VLAN ID
Protocol mode
IPv4
DHCP
8.8.8.8
;
;