Operation Manual

114 Enhanced phone functions
CTI calls
Beep on auto-answer
Speakerphone mode activates automatically on your phone if you use a CTI ap-
plication (such as Outlook) to dial a number when Auto Answer is active. If Auto
Answer is not active, the phone rings first and you have to press the loudspeaker
key or lift the handset to set up the call. This setting also defines whether or not
incoming calls are automatically accepted. If the function is active, an alert beep
sounds when a call is automatically accepted. Details regarding special applica
-
tion are provided on  Page 133.
Information on the operation of the configured CTI application can be found in
the corresponding user guide.
z
You can also configure this setting via the WBM interface  Page 265.
Prerequisite: The option was programmed by your administrator.
v Press the key shown until the "Settings" tab is active.
Confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
User
Configuration
Incoming calls
CTI calls
AutoAnswer
Yes
AutoAnswer beep
Yes
Save & Exit