Operation Manual

Enhanced phone functions 115
Beep on auto-reconnect
You can reconnect a held call both via the CTI application and via the phone. A
beep sounds when you toggle between an active call and a held call when the
function is active.
z
You can also configure this setting via the WBM interface  Page 265.
Prerequisite: The option was programmed by your administrator.
v Press the key shown until the "Settings" tab is active.
Confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
User
Configuration
Incoming calls
CTI calls
AutoReconnect beep
Yes
Save & Exit