Operation Manual

184 Video function

Holding a call

You place the call on hold for example to consult with someone else in the room.

Select and confirm the option shown in the connection's context menu. The vid-

eo display is interrupted.

Following resumption, the two small video preview images appear first and then,

after the context menu disappears, the video image of your call partner in single-

screen mode.

Installing a USB camera

You can connect most of the currently commercially available USB cameras.

Connecting a USB camera

Plug the USB connector of the camera into the USB port on the bottom of your

OpenStage

60/80 (see  Page 16).

If you see the following message, the USB camera has been detected and can

be used.

Activating and deactivating the video function

You can also configure this setting via the WBM interface  Page 265.

v Press the key shown until the "Settings" tab is active.

Confirm the option shown.

if nec. j Enter and confirm the user password.

Select and confirm the option shown.

Select and confirm the option shown.

Select the option shown.

Select and confirm the option shown in the context menu to activate.

Select and confirm the option shown in the context menu to deactivate.

Select and confirm the option shown.

Hold

New USB device detected

video.camera USB2.0 Camera

User

Configuration

Video Call

Video on

Yes

Save & exit