Operation Manual

Individual phone configuration 235
Configuring pairing settings
Pairing is used for checking the access authorisation of a Bluetooth device in a
Bluetooth network. During the pairing process, a 128-bit connection key is cre
-
ated. This is used for subsequent identification. You can specify whether pairing
should be Automatic, occur after a Prompt or not at all.
z
You can also configure this setting via the WBM interface  Page 265.
v Press the key shown until the application’s "Settings" tab is active.
Select and confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown. The Bluetooth settings dialog is selected.
Select and confirm the option shown.
Select and confirm the option shown.
or
Select and confirm the option shown.
or
Select and confirm the option shown.
Select and confirm the option shown.
Pairing is only performed the first time contact is established between a
Bluetooth device and your OpenStage. If the Bluetooth device is success
-
fully paired, no further access authorisation checks are necessary. In-
stead, each subsequent check uses the previously created connection
key.
User
Configuration
Bluetooth
Configuration
Pairing
No
Automatic
Prompt
Save & Exit