User's Manual

UGWDR82NUH50A
Solutions for a Real Time World User Manual
UM- UGWDR82NUH50A 8 45388 Warm Springs Blvd. Fremont, CA 94539
[e-mail]
TEL: [phone] FAX: [phone]
http://www.unigen.com Toll Free: [phone]
Copyright Unigen Corporation, 2009
• Part 15 Section 15.109 Sub-paragraph A, Class B Radiated Emission Limits
These emissions tests can be conducted by the manufacturer or by contacting an approved
test facility equipped and certified accordingly. The results of these emissions tests are not
required to be submitted to the FCC or Unigen, but should be kept on file by the OEM.
Co-location of Additional Transmitters
Digital Electronic Devices manufacturers using this MA grant should refer to Appendix B (FCC
Grant #) for end-products using two or more co-located RF transmitters. This grant states:
“This modular transmitter is approved for use in Digital Electronic Devices and
may operate in conjunction with other mobile and portable transmitters in the
same device; provided, the other mobile and portable transmitters have
satisfied the appropriate RF exposure requirements contained in the FCC
rules. The grantee must also provide Digital Electronic Device integrators, or
end users if marketed directly to end users, with installation and operating
instructions for satisfying RF exposure requirements. The Grantee must
inform second manufacturers/installers that in order for this module to be
operated in any configuration other than that permitted in the preceding
sentences, a separate FCC equipment authorization must be obtained for
each device into which this module is installed.“
This modular approval is granted provided Digital Electronic Devices manufacturers assume
responsibility for ensuring that other transmitters operating in conjunction with the
UGWDR82NUH50A comply with RF exposure requirements associated with their use. The use
of one or more additional RF transmitters will require review by the FCC and may require end-
product re-certification, including the UGWDR82NUH50A to ensure emissions compliance and
RF safety. It is the sole responsibility of the Digital Electronic Device manufacturer to obtain
end-product regulatory compliance for configurations including two or more RF transmitters.
Product Labeling Requirements
FCC product labeling requirements stipulate an FCC label, including specific text, be placed on
the device containing the UGWDR82NUH50A module. The product label must include the
following text and must be affixed to the exterior of the OEM’s product. The text should be
located beneath the FCC compliance logo.
“Module FCC ID: R8KUGWDR82N"