User's Manual

San Gabriel SMT-UGWDS82NSM33
Solutions for a Real Time World User Manual
UM- UGWDS82NSM33 7 45388 Warm Springs Blvd. Fremont, CA 94539
support@unigen.com
TEL: (510) 668.2088 FAX: (510) 661.2788
http://www.unigen.com Toll Free: (800) 826.0808
Copyright Unigen Corporation, 2010
Co-location of Additional Transmitters
Digital Electronic Devices manufacturers using this MA grant should refer to Appendix B (FCC
Grant #) for end-products using two or more co-located RF transmitters. This grant states:
“This modular transmitter is approved for use in Digital Electronic Devices and
may operate in conjunction with other mobile and portable transmitters in the
same device; provided, the other mobile and portable transmitters have
satisfied the appropriate RF exposure requirements contained in the FCC
rules. The grantee must also provide Digital Electronic Device integrators, or
end users if marketed directly to end users, with installation and operating
instructions for satisfying RF exposure requirements. The Grantee must
inform second manufacturers/installers that in order for this module to be
operated in any configuration other than that permitted in the preceding
sentences, a separate FCC equipment authorization must be obtained for
each device into which this module is installed.“
This modular approval is granted provided Digital Electronic Devices manufacturers assume
responsibility for ensuring that other transmitters operating in conjunction with the
UGWDS82NSM33 comply with RF exposure requirements associated with their use. The use of
one or more additional RF transmitters will require review by the FCC and may require end-
product re-certification, including the UGWDS82NSM33 to ensure emissions compliance and RF
safety. It is the sole responsibility of the Digital Electronic Device manufacturer to obtain end-
product regulatory compliance for configurations including two or more RF transmitters.
Product Labeling Requirements
FCC product labeling requirements stipulate an FCC label, including specific text, be placed on
the device containing the UGWDS82NSM33 module. The product label must include the
following text and must be affixed to the exterior of the OEM’s product. The text should be
located beneath the FCC compliance logo.
“FCC ID: RK8UGWDS82”