USER MANUAL PRO BT5 PRO SERIES AUDIO INTERFACE Bluetooth DIRECT BOX DESIGN & MADE IN TAIWAN Index GENERAL PRECAUTION BEFORE USE PRODUCT OVERVIEW CAUTION NOTE PARAMETER TEST CONDITIONS FEATURES ISO TRANSFORMER SCHEMATIC APPEARANCE PARTS & FUNCTIONS POWERED TERMINAL POWERED INDICATOR BLUETOOTH SYNCHRONIZATION METHOD MONITOR ELIMINATING GROUND LOOP NOISE Search and connect your PRO BT5 *About MAC address SYSTEM CONNECTION GUIDE SPECIFICATIONS UNiKA Electronic Co., Ltd. www.unikapro.com 6F, No.
UNiKA PRO BT5 User Manual GENERAL PRECAUTION BEFORE USE Thank you for purchasing the UNiKA PRO SERIES AUDIO INTERFACE. Before using, please read this manual carefully and pay attention to every detail that you must pay attention to. If you use a mixer to connect to this interface, please turn off the mixer power and +48V phantom power before connecting, and then turn on the power and phantom power after inserting the signal cables.
UNiKA PRO BT5 User Manual CAUTION This product has undergone rigorous inspection before leaving the factory. If customers encounter failures during use, please contact your local dealer or distributor for replacement or repairing, do not disassemble the case or replace parts by yourself, which will invalidate the warranty. For details, please refer to the warranty regulations in the enclosed warranty card, and fill in the details, and get a valid stamp or signature of the dealer or distributor.
UNiKA PRO BT5 User Manual APPEARANCE PARTS & FUNCTIONS ① Left channel signal output: XLR terminal, isolated transformer's balanced output, no need to use +48V phantom power. ① ② ④ ③ ⑤ ② Output grounding/floating switch: when the switch is not pressed,the first pin (PIN-1) of XLR is grounded. PIN-1 will be disconnected from ground after pressing. This button should depend on the system. Used in the situation, in order to isolate the ground loop noise or leakage.
UNiKA PRO BT5 User Manual POWERED TERMINAL The output side is equipped with a TYPE C USB terminal, and an external switching power supply or mobile power supply can be used to provide 5VDC voltage to make the Bluetooth module work normally. Note: Since the device does not include charging identification IC, some of power bank with QC function may not be available or may stop supplying power halfway because the IC is not detected.
UNiKA PRO BT5 User Manual Search and connect your PRO BT5 When you use your computer, mobile phone, multimedia device to search and connect to PRO BT5 via Bluetooth 5.0 or higher version, please connect the power of PRO BT5 first, then the power light on the upper cover will light up, and the SYNC indicator on the front side will flash.
UNiKA PRO BT5 User Manual SYSTEM CONNECTION GUIDE Tablet ) BLUETOOTH )))) iOS Android 5VDC POWER IN Mac OSX Connected by ISO OUT balanced wire to the mixer. No need to provide phantom power.
UNiKA PRO BT5 User Manual SPECIFICATIONS (Specifications are subject to change without notice.) PRO BT5 Circuit principle Passive/Transformer balance output Bluetooth Version Ver 5.0 A2DP DUAL MODE with BLE, DID list ready On board DA convert & sample rate 16bit / 44.
EU DECLARATION OF CONFORMITY 1. Equipment Product name Bluetooth 5.0 direct box Model PRO-BT5 EAN Code 4711064410228 2. Manufacturer Manufacturer UNiKA Electronic Co.,Ltd. Address 6F, No.168, Xinhu 2nd Roadn, Nei-Hu, Taipei, Taiwan 3. This declaration of conformity is issued under the sole responsibility of the manufacturer. 4. Object of the declaration, Product: Direct box for musical instrument and A/V device. 5.
